HONDA 2010 Accord Coupe - Manual (Page 305)

Remove the oil filter and let the
remaining oil drain. A special
wrench (available from your
dealer) is required. Open the hood, and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
Always change the oil and filter
according to the maintenance
messages shown on the information
display. The oil and filter collect
contaminants that can damage your
engine if they are not removed
regularly.
Run the engine until it reaches
normal operating temperature,
then shut it off. Make sure the oil filter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
before installing a new oil filter.
Changing the oil and filter requires
special tools and access from
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lift for this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician.
3. 2.
1.
Changing the Engine Oil and Filter
302
OIL DRAIN BOLT
WASHER
OIL DRAIN BOLT
WASHER
V6 models 4-cylinder models
09/06/25 20:19:48 31TE0620_307
2010 Accord Coupe