2 mode configuration, continued, 3 power-up, Power-up – Honeywell HEGS5001 User Manual
Page 20
3.2 MODE CONFIGURATION, CONTINUED
3. Press
or keys to scroll through the available options.
• Standalone (control KD6/HD6 PTZs only)
• Mux Mode (control multiplexers, VCRs, and KD6/HD6 PTZs)
• System Mode (must be used with HSX3208L switcher)
• Stdalone/Mux Fw. (upload new firmware to the HEGS5000). Refer to Section 7
for uploading the latest firmware.
• System Firmware (upload new firmware to the HEGS5000 system controller).
Refer to the HSX3208L User Manual to upload the latest firmware.
4. When the desired option is displayed, press Enter (
). The controller continues
booting for the selected mode.
3.3 POWER-UP
The power-up process is the same for both the MUX mode and the Standalone mode of
operation. When power is applied to the HEGS5000, the LCD displays the following
messages:
Rev. 1.01
10 900.0800
19-Jun-06
After 5 seconds, the current application starts. The selected mode (HEGS5000 or
HEGS5001) is displayed.
519685-1980 A
Booting in 5s
Boot Mngr MMDDYY
(counts down to 0)
Note: if the configuration has been changed by the user, this screen displays,
“Loaded Saved Configuration”
Then the login screen in displayed.
Two levels of login are available: Master and Operator.
519686-1980 A
System login
Password: _ _ _ _
HEGS5000 MMDDYY
519686-1980 A
HEGS5001 MMDDYY
Enter the four-digit password to logon. Refer to paragraph 3.3.1 for default passwords.