Henny Penny FM07-020-F - Manual (Page 19)

SECTION 3. PROGRAMMING
3-1. BASIC PROGRAMMING
SEQUENCE
To enter the program mode a password keystroke sequence is
required. Note that when performing this sequence the switches
must be depressed within one second of each other. If not,
the control will not enter the program mode.
1. Depress the “SELECT TIME” switch.
2. Depress the “EXIT COOL” switch.
3. Depress the “SELECT FUNCTION” switch.
4. Depress the “EXIT FILL” switch.
You are now in the program mode of the control.
3-2. COOK CYCLE
PROGRAMMING
To program a cook cycle the following steps should be followed.
1. Follow the keystroke sequence and enter the program
mode.
2. Select the product you desire to program by depressing
the cycle switch next to the product.
3. TIME will be flashing in the function display.
4. Use the four change switches beneath the display to
change the displayed values. Program the starting time
first.
5. Depress the SELECT TIME switch which allows you to
enter the second interval for time.
6. Program your second interval time. Repeat until all six
interval times have been programmed.
7. Depress the SELECT FUNCTION switch. TEMP will be
flashing in the function display.
8. Repeat steps 4, 5, and 6 until all six interval temperatures
have been programmed.
9. Depress the SELECT FUNCTION switch until PRESSURE
is flashing in the function display. Digital display will read
OFF or ON.
304 3-1