Henny Penny FM07-020-F - Manual (Page 7)

1-5. NINE-PIN CONNECTOR
WIRING
A. Remove the above wires from their existing position. These
wires will be connected to the nine-pin connector provided.
B. Locate wires number 12, 8, and 11 at the fan motor. Remove
the connector securing these wires. Wire number 11 can be
discarded at this time. Wire number 12 will be connected to the
nine-pin connector as noted on the wiring diagram. Wire
number 8 from the fan motor will be joined with wire number 15
before it is connected to the nine-pin connector. Join these two
wires using the twist-on wire connector provided.
C. Note the position of the wires on the nine-pin connector.
Reference wiring diagram Figure 2. The wires on the connector
will have corresponding numbers to those within the control
panel.
D. Using the twist-on wire connectors provided, splice the
corresponding wires together.
E. Wiring of the nine-pin connector is completed.
“Do not install the control panel at this time.”
1-6. TEMPERATURE PROBE
INSTALLATION
A. Drain the shortening from the cook pot to a level below
the position of the thermostat pot fitting.
B. Remove the thermostat capillary tube from the cook pot
as per section 5-11 of standard Henny Penny Service Manual.
C. Install the reducer fitting, Henny Penny part number
FP01-024 into the pot wall fitting. Use pipe sealant to seal
the pipe threads.
D. Install the compression fitting, part number 30094, Figure
3 into the reducer. Use pipe sealant to seal the pipe threads.
E. Install the new probe by inserting the probe into the compression
fitting until the probe extends one-half (1/2) inch into the cook pot.
Tighten the nut on the compression fitting a half a turn past the
point where the fitting first becomes tight onto the probe.
Excess force will damage the probe.
F. Installation of the temperature probe is complete.
304 1-3