Heatiator Heatilator BCDV36 - Manual (Page 14)

33606 Rev D 14 01-03
BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS
4. ASSEMBLING SLIP SECTIONS
Slip sections should be snapped into the first
mating piece, then expanded to their desired
length, making sure that a 1.5” overlap is
maintained between the two sections of the slip
section. The two sections of the slip section then
need to be secured by driving two screws through
the overlapping portions of the outer vent. See
Figure 22. This will secure the slip section to the
desired length and prevent it from separating. The
slip section can then be attached to the next section
of vent.
Figure 22
Figure 23
5. DISASSEMBLING VENT SECTIONS
(ONLY IF NECESSARY)
To disassemble any two pieces of pipe, rotate
either section so that the seams on both pipe
sections are perfectly aligned as shown in
Figure 23. They can then be carefully pulled apart.