Hand Held Products 5700 - Manual (Page 24)

SCANTEAM 5700 User’s Guide 1–16
Dual Interface Enable/Disable Selection
Power Up Delay
Laser Emulation Power Up Delay Selection
Switched Power Mode Selections
✱
Switched Power (Low Power) Mode
Enable
✱
Disable
Constant Power Mode
Dual Interface Disable Selection lets you temporarily disable the dual interface
selection, while retaining your secondary interface setup in memory. If you want
to enable the secondary interface again, scan the Enable Dual Interface bar
code below.
When this feature is enabled, the unit consumes less than 50 uA from its power
line when the trigger is not pulled. When the trigger is pulled, it consumes normal
power. This feature is used for battery powered devices to save power. If power
savings is not an issue and speed is, disable this feature for better performance.
Scan two of the Numeric Bar Codes on the Programming Chart (inside back
cover) to set the delay to any value between 00 and 99. 00–99 is the multiplier
(x5ms).
Scan the Laser Emulation Power Up Delay bar code to delay full power up. This
allows the PDT terminal to power up on scanner trigger. The PDT powers down
between scans, greatly extending battery life.