Hand Held Products 5700 - Manual (Page 86)

8–4 SCANTEAM 5700 User’s Guide
Does the scanner read your bar code incorrectly?
If the scanner reads a bar code (one beep for a good read), but the bar code
is not displayed correctly on the host screen:
➊
The scanner may not be programmed for the appropriate terminal
interface.
Example: You scan “12345” and the host displays “@es%.”
Reprogram the scanner with the correct “Plug and Play” or Terminal
Selection bar code (see Section 1).
➋
The scanner may not be programmed to output your bar code
properly.
Example: You scan “12345” and the host displays “A12345B.”
Reprogram the scanner with the proper Symbology selections (see
Section 4, Symbology Menu).
The scanner won’t read your bar code at all?
If the scanner will not read your bar code:
➊
Try scanning the Sample Bar Codes (found on the back cover of the
User’s Guide).
If the scanner reads the Sample Bar Codes, check that your bar code
is readable. (See “Is the scanner having trouble reading your bar
codes” on the previous page.)
If the scanner does not read the Sample Bar Codes either, continue
to #2, below...
➋
If the scanner won’t read the Sample Bar Codes either:
Verify that the bar code symbologies are enabled. (See Sections 4,
Symbology Menu.)
Verify that your bar code symbology is enabled. (See Sections 4,
Symbology Menu.)
Scan the “Default All... ” bar code on each symbology menu page in
Section 4 to enable most symbologies. (MSI and Plessey will have to
be enabled individually, as they are defaulted Off.)