Hand Held Products 5700 - Manual (Page 45)

3–3 SCANTEAM 5700 User’s Guide
Wake Up Pulse Selection
10 ✱
25
Transmission Rate Selection
40 80
120 150
200 300
Enable ✱
Disable
White High ✱
Black High
Output Polarity Selection
[
[ In Laser Emulation mode, the default polarity is White High. In Wand
Emulation mode, the default polarity is Black High.
This programming selection sets the transmission rate from 10 ips (inches per
second) to 300 ips if the scanner is in Wand Emulation mode. Programming the
transmission rate causes the data to be sent at the specified rate. The
programmed transmission rate must be compatible with the device receiving the
bar code data. Default = 25 ips (inches per second).
This selection provides a “wake up” pulse on the sync line from the scanner to
a portable terminal. This feature extends battery life of the portable terminal by
waking up the terminal only when data is ready to be sent. Bar code data follows
the wake up pulse after a 0.2 second delay. Default = Disable.
This selection allows you to set the output logic convention for the digital output.
The choices are White High (“Laser” output) and Black High.
Default = Black High.