Document Outline

• Declaration of Conformity
  • Compliance Information
• Contents
• About This Document
  • Who Should Use This Document
  • How This Document Is Organized
  • Contacts
  • Document Conventions
• Introduction
  • Printer Components
  • Control Panel
• Printer Setup
  • Before You Begin
  • Handling the Printer
    • Unpack and Inspect the Printer
    • Store the Printer
    • Ship the Printer
  • Select a Site for the Printer
    • Select a Surface
    • Provide Proper Operating Conditions
    • Allow Proper Space
    • Provide a Data Source
    • Provide a Power Source
  • Select a Data Communication Interface
    • Data Cables and Wireless Cards
  • Connect the Printer to a Power Source
    • Power Cord Specifications
  • Install the Control Panel Keypad Cover
  • Types of Media
  • Ribbon Overview
    • When to Use Ribbon
    • Coated Side of Ribbon
• Operations
  • Print Modes and Printer Options
    • Print Mode Descriptions and Printer Requirements
    • Media Paths
  • Prepare the Media for Loading
  • Load Media in Tear-Off Mode
  • Load Media in Peel-Off Mode
  • Load Media in Cutter Mode
  • Load Media in Rewind Mode
    • Remove Media Liner from the Rewind Spindle
  • Load Ribbon
    • Remove Used Ribbon
  • Calibrate the Printer
  • Adjust Transmissive Media Sensors
    • Upper Media Sensor
    • Lower Media Sensor
  • Adjust Printhead Pressure and Toggle Position
    • Toggle Position Adjustment
    • Printhead Pressure Adjustment
• Configuration
  • Setup Mode
    • Enter and Use Setup Mode
    • Exit Setup Mode
  • Change Password-Protected Parameters
    • Default Password Value
    • Disable the Password Protection Feature
  • Print a Configuration Label
  • Print a Network Configuration Label
  • Standard Control Panel Parameters
  • Additional Control Panel Parameters
• Routine Maintenance
  • Replacing Printer Components
    • Ordering Replacement Parts
    • Recycling Printer Components
  • Lubrication
  • Cleaning Schedule and Procedures
    • Clean the Exterior
    • Clean the Media Compartment
    • Clean the Printhead and Platen Roller
    • Clean the Sensors
    • Clean the Snap Plate
    • Clean the Cutter
  • Replace the Fuse
• Troubleshooting
  • Troubleshooting Checklists
  • LCD Error Messages
  • Print Quality Problems
  • Calibration Problems
  • Communications Problems
  • Ribbon Problems
  • RFID Problems
  • Miscellaneous Printer Problems
  • Printer Diagnostics
    • Power-On Self Test
    • CANCEL Self Test
    • PAUSE Self Test
    • FEED Self Test
    • FEED and PAUSE Self Test
    • Communications Diagnostics Test
    • Sensor Profile
• Specifications
  • Features
    • Standard Features
    • Optional Features
    • Zebra Programming Language (ZPL)
    • Bar Codes
  • General Specifications
    • Physical Specifications
    • Electrical Specifications
    • Environmental Conditions for Operation and Storage
  • Print Specifications by Model
    • 110Xi4 and R110Xi4
    • 140Xi4, 170Xi4, and 220Xi4
  • Ribbon Specifications
    • 110Xi4 and R110Xi4
    • 140Xi4, 170Xi4, and 220Xi4
  • Media Specifications
    • 110Xi4 and R110Xi4
    • 140Xi4, 170Xi4, and 220Xi4 Printers
• End User License Agreement
• Glossary
• Index