Load media in cutter mode – Zebra Technologies ZEBRA RXI4TM User Manual
Page 55
55
Operations
Load Media in Cutter Mode
1/7/10
Xi4™/RXi4™ User Guide
P1009874-002
Load Media in Cutter Mode
A cutter is a rotating knife with a self-sharpening blade that is attached to the front of the
printer. The cutter is used to cut individual labels as they are printed.
shows the printer loaded with labels in Cutter mode.
Figure 9 • Media Loaded in Cutter Mode
To set up the printer in Cutter mode, complete these steps:
1.
Set the printer to Cutter mode. See
for instructions.
2.
Insert media into the printer. See
Prepare the Media for Loading on page 39
for
instructions.
1
Printhead-open lever
2
Media guide
3
Media guide roller
4
Media supply guide
5
Media
6
Cutter
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
1
2
4
5
6
3