Connect the printer to a power source – Zebra Technologies ZEBRA RXI4TM User Manual

Page 28

Advertising
background image

Printer Setup
Connect the Printer to a Power Source

28

P1009874-002

Xi4™/RXi4™ User Guide

1/7/10

Connect the Printer to a Power Source

The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to

Power Cord Specifications on page 29

.

To connect the printer to a power source, complete these steps:

1.

Toggle the printer power switch to the off (

O

) position.

2.

Plug the power cord into the AC power connector (

1

) on the rear of the printer.

3.

Plug the other end of the power cord into a power outlet near the printer.

4.

Turn on (

I

) the printer.

The control panel LCD and lights activate, indicating that the printer is booting up.

Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.

1

Advertising
This manual is related to the following products: