Zebra Technologies ZEBRA RXI4TM - Manual (Page 64)

Operations
Load Media in Rewind Mode 64
P1009874-002 Xi4™/RXi4™ User Guide 1/7/10
13. Extend approximately 36 in. (920 mm) of media out of the printer. Remove and discard
the labels from this exposed media.
14. Remove the hook from the rewind spindle.
15. If you are using a core, slide it onto the rewind spindle until it is flush against the guide
plate.
16. Wind the media liner counterclockwise around the rewind spindle.
17. Reinstall the hook. Insert the short end of the hook into the hole in the center of the
adjusting nut (
1
). Insert the long end of the hook into the small hole on the guide plate (
2
).
Note • A core is not required.