Zebra Technologies ZEBRA RXI4TM - Manual (Page 127)

127 Routine Maintenance
Cleaning Schedule and Procedures
1/7/10 Xi4™/RXi4™ User Guide P1009874-002
RFID Printers
To clean a plastic snap plate in an RFID printer, complete these steps:
1.
2.
3. Press in the tabs on the sides of the snap plate.
4. Rotate the front of the snap plate upward.
Important • Do not use a screwdriver or other metal objects when removing the plastic snap
plate from an RFID printer. Doing so could damage the snap plate.
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Turn off ( O ) the printer and disconnect the AC power cord and all data cables.
Caution • While performing any tasks near an open printhead, remove all rings,
watches, hanging necklaces, identification badges, or other metallic objects that could
touch the printhead.
Open the printhead and remove the media and ribbon (if used).