Zebra Technologies ZEBRA RXI4TM - Manual (Page 142)

Troubleshooting
Print Quality Problems 142
P1009874-002 Xi4™/RXi4™ User Guide 1/7/10
Wrinkled ribbon Ribbon was fed through the
ribbon system incorrectly. Load the ribbon correctly. See Load Ribbon
on page 69 .
Incorrect burn temperature. Set the darkness to the lowest possible setting for
good print quality. See
Adjust Print Darkness
on page 91 .
Incorrect or uneven printhead
pressure. Set the printhead pressure to the minimum
needed for good print quality. See
Adjust
Printhead Pressure and Toggle Position
on page 82
.
Media not feeding properly;
“walking” from side to side. Make sure that media is snug by adjusting the
media guide, or call a service technician.
The strip plate needs adjusting. Call a service technician.
The printhead needs vertical
adjustment. Call a service technician.
The printhead is improperly
balanced. Call a service technician.
The printhead and platen roller
need to be realigned. Call a service technician.
Fine, angular gray
lines on blank labels Wrinkled ribbon. See wrinkled ribbon causes and solutions in this
table.
Printing too light or
too dark over the
entire label The media is not designed for
high-speed operation. Replace supplies with those recommended for
high-speed operation.
You are using an incorrect
combination of media and
ribbon for your application. 1. Switch to a different type of media or ribbon
to try to find a compatible combination.
2. If necessary, consult your authorized Zebra
reseller or distributor for information and
advice.
You are using ribbon with
direct thermal media. Direct thermal media does not require ribbon. To
check if you are using direct thermal media,
perform the label scratch test in
When to Use
Ribbon on page 33 .
Incorrect or uneven printhead
pressure. Set the pressure to the minimum needed. See
Adjust Printhead Pressure and Toggle Position
on page 82
.
Smudge marks on
labels The media or ribbon is not
designed for high-speed
operation. Replace supplies with those recommended for
high-speed operation.
Table 12 • Print Quality Problems (Continued)
Problem Possible Cause Recommended Solution