HP PROCURVE 2610 User Manual
Page 29
Advertising
2-5
Installing the Switch
Installation Procedures
In
sta
llin
g
th
e
Sw
itc
h
8.
(Optional) Connect a console to the switch (
You may
wish to modify the switch’s configuration, for example, to configure an IP
address so it can be managed using a web browser, from an SNMP network
management station, or through a Telnet session. Configuration changes
can be made by using the included console cable to connect a PC to the
switch’s console port.
At this point, your switch is fully installed. See the rest of this chapter if you
need more detailed information on any of these installation steps.
Advertising