HP PROCURVE 2610 - Manual (Page 48)

2-24
Installing the Switch
Installation Procedures
In
sta
llin
g
th
e
Sw
itc
h
The following illustration demonstrates an example of connectivity between
an RPS/EPS device and a Switch device as a PoE power supply.
Figure 2-15. Connecting a 600 RPS/EPS to a 2610 EPS
610 EPS LEDs
Figure 2-16. EPS status LEDs
For a complete description of the LEDs see the documentation that came with
the 610 EPS.
For redundant or additional PoE power, connect the 610 EPS to the switch
using one of the four supplied EPS cables. EPS cables are 2.00 meters (6.56
feet) in length.
The following illustration demonstrates an example of connectivity between
a 610 EPS device and two Switch devices as a PoE power supply.
Switch EPS output
EPS input port
Power
Fault
hp procurve
610 eps
J8169A
Fan/Temp Status flash = Temperature too high
Fan/Temp Status + Fault flash = Fan failure
Fan/Temp Status
Internal Power Status
In Ready Out Ready
Backup Power Ports Status
EPS Ports Pair A (408 W total for PoE applications)
EPS Ports: 50V 8.3A max each.
EPS A1 Power Status
A2 B1 B2 A1 Device Connected EPS A2 EPS B1 Power Status
Device Connected EPS B2
EPS Ports Pair B (408 W total for PoE applications)
Power and
Fault LEDs
610 EPS
Internal Power
Status LED
Fan/Temp
Status LED
Backup Power
Port LEDs
EPS Port LEDs
Device Connected
LED
Power Status
LED