Diagnosing with the leds, Led patterns for general switch troubleshooting, Diagnosing with the leds -4 – HP PROCURVE 2610 User Manual
Page 70: Led patterns for general switch troubleshooting -4
4-4
Troubleshooting
Diagnosing with the LEDs
T
rou
bl
esho
ot
ing
Diagnosing with the LEDs
Table 4-1 shows LED patterns on the switch that indicate problem conditions
for general switch operation troubleshooting.
Table 4-2 shows LED patterns that indicate problem conditions for PoE
troubleshooting.
LED patterns for General Switch Troubleshooting
1.
Check in the table for the LED pattern you see on your switch.
2.
Refer to the corresponding diagnostic tip on the next few pages.
Table 4-1.
LED Error Indicators
LED Pattern Indicating Problems
Diagnostic
Tips
Power
Fault
RPS
EPS
Test
Fan
Port Link LED
Off with
power cord
plugged in
1
1
1
1
1
1
On
Prolonged On
1
1
Prolonged On
1
1
On
Flashing
2
1
1
Flashing
2
1
1
On
Flashing
2
1
1
Off
Flashing
2
1
On
Flashing
2
1
1
Flashing
2
1
Flashing
2
On
Off
1
1
Off
1
Off with cable
connected
On
Off
1
1
Off
1
On, but the port is not
communicating
On
Flashing
Flashing
Flashing
1
1
➑
1
This LED is not important for the diagnosis.
2
The flashing behavior is an on/off cycle once every 1.6 seconds, approximately.