FARGO electronic Card Printer - Manual (Page 18)

Getting Started
3
Section 3: Getting Started 13
A. CHOOSING A GOOD LOCATION
Place the unit in a location with adequate air circulation to prevent internal heat
build up.
■ Use the dimensions specified in Section 10 as a guideline for the minimum
clearances to the unit.
NOTE: Allow for adequate clearance above the unit to accommodate the height of the unit with its
cover open.
■ Do not install unit (a) near heat sources such as radiators or air ducts, or (b) in a
place subject to direct sun-light, excessive dust, mechanical vibration or shock.
B. ABOUT MOISTURE CONDENSATION
If the unit is brought directly from a cold to a warm location, or is placed in a very
damp room, moisture may condense inside the unit. Should this occur, print quality
may not be optimum. Leave the unit turned OFF in a warm, dry room for several
hours before using. This will allow the moisture to evaporate.
510291_card printer 11/24/98 12:18 PM Page 13