FARGO electronic Card Printer - Manual (Page 22)

Section 3: Getting Started 17
4250/4225 Card Printer UserÕs Manual
F. INSTALLING THE CLEANING ROLLER
The printer is shipped with a Cleaning Roller separately packaged. When installed,
the Cleaning Roller removes dust particles from a blank card as it feeds into the
printer. By cleaning the cards, this roller helps prevent contaminated cards from
passing beneath the Printhead, thus extending the PrintheadÕs life and allowing for
higher quality output. Refer to the following steps to install the Cleaning Roller:
1. Remove the Cleaning Roller from its packaging.
2. Open the Top Cover of the printer by pressing the Cover Release Button.
(If you have already installed the ribbon, remove it from the printer.)
3. Lower the Cleaning Roller down into the Cleaning Roller Bracket which resides
just below the Ribbon Sensor. Note that this roller should be cleaned every 250
prints to maintain print quality and extend the life of the Printhead. Refer to
Section 7-J for cleaning instructions.
Cleaning
Roller Bracket
Ribbon Sensor
Cleaning Roller
510291_card printer 11/24/98 12:18 PM Page 17