FARGO electronic Card Printer - Manual (Page 65)

60 Section 8: Mechanical Adjustments
4250/4225 Card Printer UserÕs Manual
5. As you are looking straight into the Card Hopper, locate the Card Separator
Adjustment Wheel at the bottom center of the hopper.
6. Rotate the adjustment wheel to the left to move the Card Separator Flap
upward or to the right to move the flap downward. If inserting thinner cards,
move the Card Separator Flap upward. If inserting thicker cards, move the flap
downward.
7. When adjusted properly, the space between the Card Separator Flap and the
first Card Feed Roller should be approximately the same as the thickness of a
single card. To determine this, look inside the printer. Of the two cards left
within the Card Hopper in step 2, only the top card should appear above the
Card Separator Flap as shown in this side view illustration.
8. Once you have adjusted the Card Separator Flap to the optimum level, re-
install the ribbon and cards, and shut the printerÕs Top Cover and Card Hopper
Door.
Top Card
Card Feed Roller
Card Input Tray
Card Separator Flap
Card Separator
Adjustment Wheel
Moves Card Separator Flap Upward
Moves Card Separator Flap Downward
510291_card printer 11/24/98 12:18 PM Page 60