FARGO electronic Card Printer - Manual (Page 88)

Appendix C:
Internal Printer
Settings
C
Appendix C: Internal Printer Settings 83
A. INTRODUCTION
Your printer is equipped with an internal adjustment mode programmable through
the LCD Display. This adjustment mode allows you to change the printerÕs internal
settings for overall Image Darkness, Image Placement, Magnetic Offset, SmartCard
Offset, and Print Length. To change these settings, please refer to the remainder of
this section.
CAUTION! THESE SETTINGS ARE OPTIMIZED AT THE FACTORY AND IN MOST
CASES WILL NOT NEED TO BE CHANGED. DO NOT ALTER THESE
SETTINGS UNLESS ABSOLUTELY NECESSARY
. IF YOU DO NEED TO
CHANGE THESE SETTINGS, IT IS IMPORTANT TO WRITE DOWN THE
ORIGINAL SETTINGS ALONG WITH THE PRINTERÕS SERIAL NUMBER FOR
LATER REFERENCE.
NOTE: If adjustment to the Image Darkness or Image Placement is required, try making these
adjustments through the printer driver prior to changing the internal printer settings.
B. ADJUSTING THE INTERNAL PRINTER SETTINGS
To enter the printerÕs adjustment mode, close the printerÕs Top Cover and press
both the On/Cancel and Pause/Resume buttons at the same time. The following
message will display on the printerÕs LCD Display:
Adjust Settings?
CANCEL or RESUME
510291_card printer 11/24/98 12:19 PM Page 83