Safety precautions – FARGO electronic Card Printer User Manual

Page 8

Advertising
background image

Safety Precautions

Section 2: Safety Precautions 3

2

Before operating the unit, please read the following safety precautions carefully.

WARNINGS

CAUTION!

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT
TO RAIN OR MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE FRONT, TOP OR BACK PANELS. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

Operate the unit only on 100-240 VAC, 50/60 Hz. If you have any doubt as to
whether you have a unit with the correct voltage rating for your countryÕs
power supply, DO NOT attempt to use the unit. Contact your dealer or the
factory.

Stop operation immediately if any liquid or solid object should fall into the
cabinet. Unplug the unit and have it checked by qualified service personnel.

Unplug the unitÕs power transformer from the wall outlet if you do not use the
unit for a long time. Disconnect the cord by grasping the plug. Never pull the
cord itself.

The unit is not disconnected from the main power source as long as the power
transformer is plugged into the wall outlet, even if the unit itself has been
turned off.

Do not disassemble the cabinet. Refer servicing only to qualified personnel.

Service personnel: parts of this device may be damaged if exposed to static
electrical discharges generated by various means, such as walking on a
carpeted floor. To avoid potential damage, always wear an appropriate
personal grounding device, such as a wrist strap (with integral resistor)
connected to an ESD ground. Or, at a minimum, make positive contact with the
bare metal chassis of the printer with your hand prior to touching any internal
electrical components.

510291_card printer 11/24/98 12:18 PM Page 3

Advertising