FARGO electronic PERSONA C10 - Manual (Page 132)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
132
Replacing the Stepper Motor Assembly (810113)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to
static electrical discharges. (Discharges may be generated by various means, such as
walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge
(ESD) procedures while handling cables in or near the Circuit Board and Printhead
Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap
with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum,
make positive contact with the bare metal chassis of the printer with the hand before
proceeding with the procedure.
Refer To Drawing 830117-XX.
TTR: 5 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2 Remove two Screws (130938) from the Stepper Motor Assembly that secures
the assembly to the printer chassis.
3 Disconnect the cable connector from J17 on the Power Circuit Board. See
Drawing 810113 for specifications.
4 Take the Stepper Motor Assembly from the printer. (Note: Be sure there is
adequate grease applied to the pinion gear of the Stepper Motor Assembly.
Also ensure that the gear mates properly with the Idler Gear before tightening
the two Screws.)