FARGO electronic PERSONA C10 - Manual (Page 36)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
36
Printing a Self Test
Now that Ribbon and cards are installed, a self test should be performed to check for proper
operation of the Printer. The standard self test function requires only that a full-color Ribbon
and at least one card is installed. A sample of the self test pattern is shown below.
Step Procedure
1 • If power is ON, turn it OFF now by pressing the On/Cancel button. (Note:
The LED indicator lights should no longer be illuminated.)
• Verify that a full-color Ribbon is installed and that cards are properly
loaded.
2 Press and hold the on-line button.
3 While holding the on-line button down, turn the Printer power back ON by
quickly pressing and releasing the On/Cancel button.
4 Release the on-line button. (Note: The gray scale self test pattern will begin
printing approximately 10 seconds after the on-line button is released.)
Self Test Example: (Actual size)