FARGO electronic PERSONA C10 - Manual (Page 5)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
5
Adjusting the RP3 Potentiometer _____________________________________________ 103
Aligning the Stepper Motor __________________________________________________ 104
Calibrating the Ribbon ID Sensor Board________________________________________ 105
Calibrating the Ribbon ID Sensor Board________________________________________ 106
Calibrating the Ribbon ID Sensor Board________________________________________ 107
Interfacing Information _______________________________________________________ 108
Centronics-type Parallel Interface _____________________________________________ 108
Section 6: Parts Replacement __________________________________________________ 112
Safety Messages (review carefully)______________________________________________ 112
Reviewing the Drawing Index ________________________________________________ 114
Reviewing the Print Circuit Board Cable Connector Locations ______________________ 115
Replacing the Rear Pivot Cover (830168)_______________________________________ 116
Replacing the Front Cover Assembly (830182-02) ________________________________ 117
Replacing the Print Circuit Board (140300) _____________________________________ 118
Replacing the Power Circuit Board (140302) ____________________________________ 119
Replacing the Printhead Assembly (820102) ____________________________________ 120
Replacing the Printhead Harness Assembly (830162-00) ___________________________ 121
Replacing the Ribbon Sensor Board Assembly (830151) ___________________________ 123
Replacing the Cleaning Roller Assembly (830177) _______________________________ 124
Replacing the Front Panel Board Assembly (830164) _____________________________ 125
Replacing the Left Card Sensor Assembly (830135) ______________________________ 126
Replacing the Headlift Motor Assembly (830143) ________________________________ 127
Replacing the Card Feed Assembly (830145) ____________________________________ 128
Replacing the Ribbon Drive Assembly (830147) _________________________________ 129
Replacing the Slotted Sensor Mount Assembly (830149)___________________________ 130
Replacing the Lid Sensor Assembly (830150) ___________________________________ 131
Replacing the Stepper Motor Assembly (810113)_________________________________ 132
Replacing the Ribbon ID Sensor Board Assembly (763173-2)_______________________ 133
Replacing the Card Feed Switch Assembly (830136) ______________________________ 134
Replacing the LED Board Assembly (830133) ___________________________________ 134
Replacing the Platen Roller (810261) __________________________________________ 135
Replacing the Card Input Roller (810262)_______________________________________ 136
Replacing the Left Card Input Roller __________________________________________ 137
Replacing the Card Feed Roller (810304) _______________________________________ 138
Replacing the Magnetic Head Assembly (High-Coercivity: 83019012 or Low Coercivity:
83019012) _______________________________________________________________ 139
Installing the New Magnetic Head Assembly ____________________________________ 140
Section 7: Maintenance and Cleaning____________________________________________ 141
Safety Messages (review carefully)______________________________________________ 141
Supplies Required _________________________________________________________ 143
Standard Printhead Cleaning _________________________________________________ 144
Expanded Printhead Cleaning ________________________________________________ 145
Cleaning the Printer Case ___________________________________________________ 146
Cleaning the Inside of the Printer _____________________________________________ 146
Cleaning the Card Feed Rollers _______________________________________________ 147
Cleaning the Drive Roller ___________________________________________________ 148
Maintaining the Cleaning Rollers _____________________________________________ 149
Section 8: Packing the C10/M10 Card Printer_____________________________________ 150
Section 9: Board Level Diagnostics ______________________________________________ 151