FARGO electronic PERSONA C10 - Manual (Page 137)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
137
Replacing the Left Card Input Roller
Step Procedure
1 Unplug the power cord from the printer.
2 Take off the Rear Pivot Cover.
3 Detach the Print Circuit Board from the chassis. Do not remove any wire
connectors unless indicated.
4 Stand at the front of the Chassis Assembly; remove the Retaining Ring
(140048) from the Card Input Roller Shaft.
5 Remove the Transport Roller Gear.Be sure to note that the wide part of the
gear hub faces the Sideplate. Remember this when reinstalling it.
6 Remove the Washer Spring (130951). Be sure to note that the wave of the
spring faces out. Remember this when reinstalling it.
7 Stand at the rear of the Chassis Assembly; remove the Ribbon Drive
Assembly.
8 Remove the Retaining Ring (140062) from the Card Input Roller Shaft.
9 Remove the two Drive Roller Bearings (760343) from the Card Input Roller.
10 Guide the Shaft forward and out of the rear Sideplate.
11 Angle the Card Input Roller up.
12 Slide the Shaft out of the front Sideplate.
13 Take the Card Input Roller out of the printer.