Section 9: board level diagnostics, Sensor testing, Reviewing the motor voltages (when active) – FARGO electronic PERSONA C10 User Manual
Page 151
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
151
Section 9: Board Level Diagnostics
The purpose of this section to provide the User with specific Board Level Diagnostic
procedures for Board Errors and Sensor Testing for the C10/M10 Card Printer.
Sensor Testing
Step Procedure
1
Check the voltage to determine if a Sensor is working.
2
a. Test the voltage of each Sensor using ground (GRD = Chassis) to the
correct pin on each connector. See the Sensor Location and Voltages
table on the next page.
b. Block a Slot Sensor with a card.
c. Cover a reflective Sensor with a card.
Reviewing the Motor Voltages (when active)
Use this table as a reference tool for Board Level Diagnostics.
Motor Location
Pin VDC
Print Drive Stepper
J22
4
5
Print Headlift
J27
1
17.0
Card Feed
J28
4
20
Ribbon Drive
J25
2
5