FARGO electronic PERSONA C10 - Manual (Page 35)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
35
Applying Power (continued)
Step Procedure
2 Plug the DC power plug end of the transformer cord into the Power Input Port
on the rear panel of the Printer. (Note: Optional external transformer must be a
Listed Class 2 device with an output rating of 16.5 volts and 3.5 amps AC
(alternating current).
The alternating current should be between 50 and 60 Hz.)
3 Plug the AC power plug end of the transformer cord into an available wall outlet.
(Note: The wall outlet should be located near the Printer and should be easily
accessible.)
Power is automatically applied to the Printer when it is plugged in.
Press the On/Cancel button if you wish to turn the Printer OFF.