FLO TV PTV350 - Manual (Page 7)

Getting Started
FLO TV Confidential and Proprietary 7 May contain U.S. and international export controlled information
1.3.1 Installing the battery
1. Open the viewing stand to reveal the back cover.
2. Remove the back cover by sliding it in the direction towards the side where the connectors
and device buttons are located.
3. Align the battery’s exposed copper contacts with the battery connectors in the battery
compartment then gently push the battery into place.
4. Replace the back cover.
1.3.2 Charging the battery
Your device should be shipped with a partially charged battery.
A low battery notification can be manually dismissed, but you will want to connect the device to
a power charger to continue watching the FLO TV service.
To charge the battery
! Provide power to the device using one of the following methods:
" Connect the device directly to a power outlet using the adapter.
" Connect the device to a powered-on PC using the USB cable.
Once connected, the battery indicator LEDs light up one after another until the battery is fully
charged. After disconnecting the charger, the LEDs remain lit for 5 seconds, indicating the
power level, and then turn off.
You can safely recharge the battery at any time, even if it has a partial charge.