FLO TV PTV350 - Manual (Page 9)

Getting Started
FLO TV Confidential and Proprietary 9 May contain U.S. and international export controlled information
! Avoid dropping the device or battery. If the device or battery is dropped, especially on a hard
surface, an internal short-circuit can occur and pose a safety hazard. If you suspect battery
damage, take it to a service center for inspection.
! Improper battery use may result in a fire, explosion, or other hazard.
Heed service markings
! Do not service any product yourself. Any service required on internal components should be
done by an authorized service technician or provider.
Damage requiring service
! Unplug the product from the electrical outlet and refer servicing to an authorized service
technician or provider under the following conditions:
" Liquid has been spilled or an object has fallen into the product.
" The product has been exposed to rain or water.
" The product has been dropped or damaged.
" There are noticeable signs of overheating.
" The product does not operate normally when you follow the operating instructions.
Avoid hot areas
! The product should be placed away from heat sources such as radiators, heat registers, stoves,
or other products (including amplifiers) that produce heat.
Avoid wet areas
! Never use the product in a wet location.
! Avoid using your device after a dramatic change in temperature.
! When you move your device between environments with very different temperatures and/or
humidity ranges, condensation may form on or within the device. To avoid damaging the
device, allow sufficient time for the moisture to evaporate before using the device.
NOTE: When taking the device from low-temperature conditions into a warmer environment or
from high-temperature conditions into a cooler environment, allow the device to
acclimate to room temperature before turning on power.
Avoid pushing objects into product
! Never push objects of any kind into cabinet slots or other openings in the product. Slots and
openings are provided for ventilation. These openings must not be blocked or covered.
Avoid unstable mounting
! Do not place the product on an object with an unstable base.