Fortress Technologies ecure Wireless Access Bridge - Manual (Page 123)

Fortress Bridge: Command-Line Interface
113
16 Disconnect the WAN ports of the new and master Bridges.
17 Power cycle the new Bridge.
The new Bridge is ready to be deployed on the network.
6.8.3.2 Deleting a Bridge from a SAC Network
You can view the current list of SAC Peers from the master/
root Bridge’s CLI with
show sp :
[GW]> show sp
Peer1=>Serial_Number:24773196
Peer2=>Serial_Number:24743196
You can determine the serial number of a particular SAC Peer
by executing
show sac from the CLI of the Bridge in question:
[GW]> show sac
SwabSerialNum:24773196
SwabConfigID:16284
SwabSACRole:SAC_SLAVE
SwabSACState:SAC_INIT4SWAB
SwabSACVer:SAC_VER_PEGASUS_ARCH1
Use the del command—from the master/root Bridge’s CLI—to
delete a Bridge from the master/root Bridge’s SAC Peer list and
from the SAC network:
[GW]> del sp <serialnumber>
where <serialnumber> is the serial number of the Bridge you
want to remove from the network.
SAC commands are valid only in Gateway mode (refer to
Section 6.1.1 for more detail).