Fortress Technologies ecure Wireless Access Bridge - Manual (Page 26)

Fortress Wireless Access Bridge: Installation
16
NOTE: The Bridge
CLI provides ac-
cess to some configu-
ration settings that
cannot be accessed
from the Bridge GUI.
13 After the Bridge reboots, change the CLI password
(according to the instructions in Section 6.4.4.2) and
configure unique SSIDs for the Bridge (according to the
instructions in Section 3.3).
If you want to use the received signal strength indicator
(RSSI) to aim the antenna of a non-root Bridge, you may
want to enable it now (refer to Section 3.3.2.7).
14 Disconnect the LAN, WAN and antenna ports in advance of
weatherizing and mast-mounting the Bridge.
CAUTION: Do not
assemble the con-
nector boot without first
referring to these in-
structions. Several as-
sembly steps are
irreversible.
Incorrectly
assembled connector
boots are unusable
,
and cannot be disassem-
bled.
2.4.3 Weatherizing the Bridge
All front-panel ports must be disconnected before you can
install the Weatherizing Kit.
To install the Weatherizing Kit:
1 Install the RJ-45 connector boot assembly on the end of the
cable that you will be plugging into the Fortress Bridge’s
WAN port, as shown in Figure 2.2:
™ If the RJ-45 connector is equipped with a molded
plastic boot, remove it from the connector. (Some
Ethernet cable connectors have a molded plastic outer
casing that is not designed for removal. This style of
connector is incompatible with the connector boot.)
Figure 2.2 Installing the RJ-45 Connector Boot Assembly