Fortress Technologies ecure Wireless Access Bridge - Manual (Page 95)

Fortress Bridge: Command-Line Interface
85
The CLI displays the configurable fields for set network one at
a time. Enter a new value for the field—or leave the field blank
and the setting unchanged—and strike
Enter ↵ , to display the
next field. The final reboot query displays only when you have
entered a value into at least one of the fields presented.
Entering the 0 (zero) argument for the DefaultGateway option
deletes the default gateway from the Bridge’s network
configuration.
Alternatively, you can run set network non-interactively with
valid switches and arguments in any order and combination:
[GW]> set network [-h <BridgeName>] [-ip <BridgeIP>] [-nm <BridgeSubnet>] [-gw <DFLTgatewayIP>|0]
Regardless of the method you use to reconfigure these
settings, you must reboot the Bridge in order for the change to
any network setting other than host name to take effect. To do
so, simply strike
Enter ↵ at the prompt ( Y is the default).
The set network command is valid only in GW (gateway)
mode (refer to Section 6.1.1 for more detail).
6.4.2 Spanning Tree Protocol in the CLI
STP link managementis enabled on the Fortress Bridge by
default.
You can view whether STP is currently enabled ( on ) or
disabled ( off ) with show stp :
[GW]> show stp
On