Fortress Technologies ecure Wireless Access Bridge - Manual (Page 85)

Fortress Bridge: Monitoring and Diagnostics
75
5.5 Diagnostics
NOTE: Radio 1
uses antenna port
1 ( ANT1 ) ; Radio 2 uses
antenna port 2 ( ANT2 ) .
Access Fortress Bridge diagnostic utilities by logging into the
Bridge GUI admin account and selecting
DIAGNOSTICS from the
menu on the left.
The DIAGNOSTICS screen displays:
‹ The version and build number of the firmware currently
running on the Fortress Bridge, under
SOFTWARE VERSION .
‹ The DEVICE ID of the Fortress Bridge, as uniquely generated
for each device on a Fortress-secured network and used,
when applicable, for device authentication. (Refer to
Section 4.1 for more information about Device IDs.)
5.5.1 Pinging a Device
1 Log on to the Bridge GUI admin or operator account and
choose
DIAGNOSTICS from the menu on the left.
2 On the DIAGNOSTICS screen under UTILITIES , in Ping IP
Address, enter the IP address of the device you want to
ping.
3 Click GO . The Bridge will ping the target IP five times and
display the PING RESULTS .
5.5.2 Tracing a Packet Route
1 Log on to the Bridge GUI admin or operator account and
choose
DIAGNOSTICS from the menu on the left.
2 On the DIAGNOSTICS screen under UTILITIES , in Traceroute
IP Address, enter the IP address of the device to which you
want to trace the route.
3 Click GO . The Bridge will trace the route to the target IP and
display the TRACEROUTE RESULTS .
detail: