Fortress Technologies ecure Wireless Access Bridge - Manual (Page 57)

Fortress Bridge: Configuration
47
To configure the default user authentication and device
state for authenticating devices:
1 Log on to the Bridge GUI admin account and select
SECURITY SETTINGS from the menu on the left.
2 In the AUTHENTICATION SETTINGS frame, in Auth Mode ,
ensure that Local authentication is enabled and that Device
Auth is selected under AUTHENTICATION OPTIONS (refer to
sections 3.6.6.1 and 3.6.6.4, respectively).
NOTE: You can
change the user
authentication and de-
vice state settings for
devices individually—
on the
DEVICE AUTHEN -
TICATION screen, de-
scribed in Section 4.1.2.
3 Under AUTHENTICATION OPTIONS , to the right of Device Auth :
™ check the box beside with User Auth by default to enable
user authentication for new devices by default. (This is
the default setting.)
or
™ clear the checkbox beside with User Auth by default to
disable user authentication for new devices by default.
4 Under AUTHENTICATION DEFAULTS , in the Device State field,
select one of:
™ Allow - the device will be allowed to connect.
™ Pending - connection requires administrator action
(explicitly changing the device’s Auth State to Allow ).
™ Deny - the device is not allowed on the network.
5 Click Apply at the bottom of the screen.
NOTE: When the
Bridge is in black-
out mode, you can tem-
porarily toggle front-
panel LEDs back on—to
use them during front-
panel configuration—by
pressing
SW1 on the
front panel.
3.7 Blackout Mode
The BLACKOUT MODE setting on the Fortress Bridge globally
turns the front-panel LEDs on and off.
When BLACKOUT MODE is Enabled , none of the front-panel
indicators will illuminate for any reason—except for a single,
initial blink (green) of less than half a second, at the beginning
of the boot process.
When BLACKOUT MODE is Disabled (the default), the front-panel
LED indicators function normally.
Front-panel LED behaviors and their associated meanings are
covered in Section 5.6.
detail:
detail: