FMI CGMFN - Manual (Page 5)

www.fmiproducts.com 119315-01D 5
pRoDUCT
iDENTiFiCaTioN
Piezo
Ignitor
Screen
Access
Door
Log
Control
Knob
Figure 1 - Vent-Free Mini Compact
Fireplace
pRoDUCT FEaTUREs
SAFETY PILOT
This fireplace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room fireplaces. The ODS/pilot
shuts off the fireplace if there is not enough
fresh air.
ELECTRONIC IGNITOR
(Remote-Ready Models Only)
This heater has an electronic ignitor to light
heater fuel supply.
opTioNal REMoTE
CoNTRol aCCEssoRiEs
(For Remote-Ready Models Only)
There are four optional remote controls that
can be purchased separately for Remote-
Ready Models only:
• wall switch
• hand-held ON/OFF remote
• wall thermostat
• hand-held thermostat remote
See Accessories, page 34.
assEMBly
WARNING: Always have
screen in place before operating
fireplace. This prevents exces-
sive temperatures on fireplace
surfaces.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this fireplace
may result in property damage
or personal injury.
ASSEMbLING FIREPLACE
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
• scissors
1. Remove two screws that hold fireplace
screen in place for shipping. These
screws are located near top of screen.
Discard screws. Lift fireplace screen up
and pull out to remove (see Figure 2, page
6). Set screen aside until installation has
been completed.
2. Remove all packaging from inside of unit.
3. Remove bubble wrap from logs and
discard.
Brick
Liners
Electronic
Ignitor
Screen
Access Door
Log
Control
Knob
Brick
Liners
Remote
Control