FUJITSU ScanSnap S500 - Manual (Page 40)

22
2.2 Connecting ScanSnap to your PC
Follow the procedure below to connect ScanSnap to your personal computer.
1. Connect ScanSnap to a power outlet using the AC cable.
2. Connect ScanSnap to your personal computer using the USB cable.
The following describes each of the above two procedures.
■ Connecting the AC Adapter
Connect the power cable as shown below.
Operation
1. Connect the AC cable to the AC adapter.
2. Connect the AC adapter to the AC adapter connector on ScanSnap and to a power outlet.
ATTENTION
• Be sure to connect the AC cable first before connecting the USB cable.
• Be sure to install ScanSnap Manager to your personal computer before con-
necting ScanSnap to your personal computer. (For details about the installa-
tion, refer to "Installing ScanSnap" (page 6)).
ATTENTION
Do not use cables other than the ones supplied with this product.
Use only specified AC cable and AC adapter.
AC cable
AC adapter
Outlet
Inlet