Furuno MARINE VHF RADIOTELEPHONE FM-3000 - Manual (Page 17)

2.Basic Operation
8
2.3 Call Channel Programming
Call channel is used to select Channel 9 (default), however,
you can program the call channel with your most often-used
channels in each channel group for quick recall.
q While pushing [HI/LO], push [CH/WX] ( ) one or
more times to select the desired channel group (U.S.A., In-
ternational, Canada) to be programmed.
w Push [16] ( ) for 1 sec. to select call channel of the se-
lected channel group.
• “CALL” and call channel number appear.
• The order of indication precedence is “SP OFF,” “LOCAL” and
“CALL.”
e Push [16] ( ) again for 3
sec. (until a long beep
changes to 2 short beeps)
to enter call channel pro-
gramming condition.
• Channel number starts blinking.
r Rotate [CHANNEL] to se-
lect the desired channel.
t Push [16] ( ) to program
the displayed channel as
call channel.
• Push [CH/WX] ( ) to cancel.
• The channel number stops blinking.
2.4 Channel Comments
Memory channels can be tagged with alphanumeric com-
ments of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " #
$ % & ' ( ) * + , - . / =) and space can be used.
q Select the desired channel.
• Cancel dualwatch, Tri-watch or scan in advance.
w While pushing [HI/LO], push [16] ( ) to edit the channel
comment.
• A cursor appears and blinks.
e Select the desired character by rotating [CHANNEL] or by
pushing [Y Y]/[Z Z] on the microphone.
• Push [CH/WX] or [SCAN] to move the cursor forward or back-
ward, respectively.
r Push [16] ( ) to input and set the comment.
• Push [HI/LO] to cancel.
• The cursor disappears.
t Repeat steps q to r to program the other channels, if de-
sired.
9
INT
25W
TAG
äLEASURE
9
U/I/C DW
9
9
9
U/I/C DW
INT
25W CALL
TAG
CALLING
INT
25W CALL
DUP TAG
INTL