Furuno MARINE VHF RADIOTELEPHONE FM-3000 - Manual (Page 46)

7. Set Mode
37
Beep tone
Beep
Scan mode
Scan Mode
Weather alert
WX Alert
Scan resume timer
Scan Timer
Attenuation level
Attenuation
Level
Internal speaker
Internal
Speaker
Scrambler code*
Scrambler
Code
Dual/tri watch
DUAL/TRI
DSC watch
DSC Watch
LCD contrast
LCD
Contrast
Automatic acknowledgement
AUTO ACK
Push
* Scrambeler code is available only
when FM-3030 is installed.
Push when using FM-3010
DSC Watch, Internal Speaker
and AUTO ACK items are not selectable
when using FM-3010.
7.1 Set Mode Programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan mode (Normal or Priority), scan re-
sume timer, weather alert, Dualwatch/Tri-watch selection,
DSC watch, transceiver’s beep tone (transceiver or FM-
3010), internal speaker, LCD contrast (transceiver or FM-
3010), RF attenuation level, scrambler code and automatic
acknowledgement.
q Turn power OFF.
w While pushing [16] ( ), turn power ON to enter Set mode.
e After the display appears, release [16] ( ).
r Push [16] ( ) to select the desired item.
Or push [16] ( ) on the FM-3010 to select the item when
using an optional FM-3010.
t Rotate [CHANNEL] to select the desired condition of the
item. Use [Y Y]/[Z Z] when using an optional FM-3010.
y Turn power OFF, then turn ON again to exit Set mode
9
9
9
9
• SET MODE CONSTRUCTION
1. Available functions may differ depending on dealer set-
ting.
2. The optional FM-3010 has it’s own settings for the beep
tone and LCD contrast.