FARGO electronic FARGO DTC 400 - Manual (Page 200)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6) 6-22
Using the Resin Heat (K) option (Front and Back)
Use this option to control the amount of heat the Printer uses when printing with the resin
black panel(s) of a full-color Ribbon or when printing with a resin-only Ribbon by adjusting
the Resin Heat slide.
Step Procedure
1 Adjust the Resin Heat, Front (K) or the Resin Head, Back (K) as needed.
• Move the slider to the left to cause less heat to be used in the printing
process, causing resin images to be lighter or less saturated.
OR
• Move the slider to the right to (a) cause more heat to be used or (b)
cause the resin image to be darker or more saturated.
(Note: This control can be helpful for fine-tuning the transfer of resin text
and bar codes.)