Flipper table module installation, Flipper table module installation -13 – FARGO electronic FARGO DTC 400 User Manual
Page 42
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
3-13
Flipper Table Module Installation
The Flipper Table Module Assembly (D900200) is an automated Flipping Module that allows
the Printer to print on the front side and back side of each card.
• See
Installing the Flipper Table Module Assembly (D900200)
procedure.
• See
Flipper Table Module Assembly Problems
• See
the
Print Both Sides option in the
Using the Device Options tab (DTC400)
section.
• See
the
Front and Back radio buttons in the
Using the Overlay / Print Area tab (DTC400)
section.
• See
the
Front and Back radio buttons in the
Using the K Panel Resin tab (DTC400)
section.
• See the DTC400 Card Printer Service Manual for the replacement procedures for this
Printer.