FUJITSU M3099EX/EH - Manual (Page 166)

4-36 M3099EX/EH OEM Manual
Replace the belt as follows:
WARNING
Wait at least 3 minutes after turning off the power before
replacement.
3 Disconnect the two relay
connectors on the roller
ASY.
4 Push the two levers (green)
towards each other to dis-
engage with the upper
locking holes and lower
down the two levers until
they engage with the two
levers locking holes.
Guide
Guide plate
Hopper table
5 Lift the document sensor
unit and keep it at the
upper position with one
hand and pull the roller
ASY out with the other
hand.
6 Move the guide on the
hopper table completely to
the end.
Belt Replacement
1 Turn off the power switch.
Make sure that the hopper
table is at the bottom.
2 Open the upper transport
unit. (See page 4-2)
Upper transport unit
Operator panel
Power switch
Lever
Lever (green)
Roller ASY