FIC M296 - Manual (Page 125)

FIC M295 / M296 Disassembly Instruction
Screws of
Heat Sink Plate
Remove cooling fan
module by slightly
lifting it up
Remove the Cooling Fan
4. Release four screws as shown in the picture above and then remove cooling fan module by
slightly lifting it up. Be careful about two fan power cables connected to DC-DC board and
main board.
7. Removing the CD-ROM Drive
The procedures for removing and replacing the CD-ROM drive is as follows:
1. Before removing the CD-ROM drive, you need to disassemble keyboard first.
2. To remove the CD-ROM drive, just remove one screw securing the CD-ROM bracket and
push out the drive from the connector.
3. Slowly slide the CD-ROM drive out of the base unit.
Screws
Push & Slide
This Way
Remove CD-ROM Drive
FIC M295 / M296 Disassembly Instruction
P - 7