FIC M296 - Manual (Page 132)

FIC M295 / M296 Disassembly Instruction
16. Removing the USB Board
The procedures for removing USB Board are as follows.
4. Before removing the USB Module Board, you need first to remove all basis unit modules
mentioned in the previous sections including main board.
1. The USB Board is configured at the lower-left side of the base unit, just under PCMCIA
slot cover.
2. Release the connector cable first which is connected to main board.
Three Screws
Remove USB board
3. Remove three screws securing the USB board as indicated on the figure above.
4. Slowly lift the entire USB board from the base unit.
P -14
FIC M295 / M296 Disassembly Instruction