Frymaster LOV BIELA14 - Manual (Page 33)

1-26
8. “Filling” is displayed during fill.
9. Release button to stop filling.
10. “Continue Filling? Yes/No” is displayed.
11. Press “8” to exit.
FILL JUG FROM BULK:*
1. When “Orange” indicator light is on, the top-off jug is empty.
2. To refill jug press and hold the orange reset button above the jug until the jug is full.
3. Release the button to stop filling.
*NOTE: The jug may not fill if any of the following are in progress:
If FILTER NOW? YES/NO, CONFIRM YES/NO, or SKIM VAT is displayed, the fill jug button is disabled until either a
filter is complete or until no is chosen.
The system also checks these conditions. The following must be met before jug fill is allowed.
Solenoid closed
• Orange fill button pressed longer than 3 sec.
• Waste valve closed
• Filter Now? Yes/No, Confirm Yes/No, or Skim Vat cannot be displayed
• System power cycle (all boards – computers, MIB, AIF and ATO) after changing setup from JIB to Bulk (use
momentary reset). Ensure reset is pressed and held for at least ten seconds.
• No filtration or other filter menu selection can be in process.
Other factors that may not allow fill jug from bulk –
• Defective solenoid
• Defective switch
• RTI pump issue
• RTI relay stuck
If using two fryer systems that are both attached to the RTI system, they may not be able to fill both units at the same
time if they have an RTI unit with a single head. Some RTI units have dual heads which can fill simultaneously.