Fostex MR-8 - Manual (Page 10)

10
MR-8 Owner’s Manual
ENTER MENU
CURSOR
UNDO
/REDO
CONTRAST
0 RETURN
TIME BASE
SELECT
STORE B / OUT A / IN PLAY MODE
AUTO PUNCH RESET
RECORD STOP PLAY REWIND F FWD
MASTERING
BRIGHT NATURAL POWERFUL
BOUNCE
1-6 > 7/8
1-4 > 5/6
HALL
DELAY
REC
SELECT
PAN
EFFECT
SEND
INPUT A
L R L R L R L R
0 10 0 10 0 10 0 10
BRIT STACK US METAL 60's COMBO
DYNAMIC CONDENSER TUBE REVERB / DELAY TIME
MIN MAX
ROOM
PLATE
MIC SIMULATION
AMP SIMULATION
MIC
BAL
UNBAL
/GUITAR
BAL
UNBAL
MIN MAX
2 1
R L
PHONES
STEREO OUT INPUT A INPUT B
EFFECT
DISTORTION TRIM TRIM
PEAK
LINE MIC
PEAK
LINE MIC MIN MAX
MASTER 7 / 8 5 / 6 4 3 2 1
MAX
MIN
MAX
MIN
LOCATE REC END
LOCATE ABS ZERO
DIGITAL MULTITRACKER
-1 +1
LOCATE
7/8 >
+ - _ 0
A B C 1 D E F 2 G H I 3 J K L 4
Y Z 9 V W X 8 S T U 7 P Q R 6 M N O 5
NO YES
GUITAR
PHONES VOL
INPUT A SELECT
COUNTER
STEREO
WAV FILE
DELETE
A - B PLAY
1 3
8 9
10
13
14
15
16
2
12
11
4 5 6 7
Top panel (left part)
Names and Functions
1. [INPUT A] connectors
Both the [BAL] XLR and [UNBAL/GUITAR] phone
connectors are provided. You can connect a gui-
tar, microphone, keyboard, etc. According to the
source connected, select the [INPUT A SELECT]
switch appropriately.
To record a mono source, use only the [INPUT A]
section. To record a stereo source, use both the
[INPUT A] and [INPUT B] sections (see page 29).
<NOTE>
On each input section, the [UNBAL/GUITAR]
phone connector takes priority to the [BAL]
XLR connector. You cannot use both the
[UNBAL/GUITAR] and [BAL] connectors on the
same section simultaneously.
2. [INPUT B] connectors
Both the [BAL] XLR and [UNBAL] phone connec-
tors are provided. You can connect a micro-
phone, keyboard, etc.
This section is used only when recording a ste-
reo source. When recording a mono source, this
section is not used (see page 29).
<NOTE>
On each input section, the [UNBAL] phone
connector takes priority to the [BAL] XLR con-
nector. You cannot use both the [UNBAL] and
[BAL] connectors on the same section simul-
taneously.
3. [STEREO OUT] jacks (L, R)
These jacks output the stereo (L and R) buss sig-
nals. Connect these jacks to a monitor equipment
or master recorder (see page 26).