Fostex MR-8 - Manual (Page 84)

84
MR-8 Owner’s Manual
flashing
Editing the tempo map
You can edit the tempo map you created.
1) While the display shows the tempo map screen,
use the [CURSOR / ] key to highlight the setting
you want to change, then press the [ENTER] key.
The display changes to show the screen where the
bar number currently set is highlighted, showing
that you can now edit it.
2) Use the [CURSOR / ] keys to enter a desired bar
number.
3) Use the [CURSOR ] key to highlight the beat
number currently set.
You can now edit the beat number.
4) Use the [CURSOR / ] keys to enter a desired
number.
5) Use the [CURSOR ] key to highlight the tempo
value currently set.
You can now edit the tempo value.
6) Use the [CURSOR / ] keys to enter a desired
tempo value.
7) After editing is completed, use the [CURSOR ]
key to move the cursor to "[ENTER]" at the lower
center of the screen, then press the [ENTER] key.
The new tempo setting above is now effective, while
the display changes to show the tempo map screen.
8) To exit the menu mode, press the [MENU] key.
You can also exit the menu mode by pressing the
[CURSOR ] key as many times as required until
exiting the menu mode.
Deleting an unnecessary tempo setting
You can delete an unnecessary tempo setting
from the tempo map.
1) On the tempo map screen, use the [CURSOR / ]
key highlight the tempo setting you want to delete,
then press the [ENTER] key.
The display changes to show the screen where the
bar number currently set is highlighted, showing
that you can now edit it.
2) Use the [CURSOR ] key to move the cursor to
"[DEL]" at the lower right of the screen, then press
the [ENTER] key.
The selected setting is immediately deleted and the
subsequent settings go up in the list.
The following shows the screen examples for
deleting "12bar 1 -> 120bpm".
3) To exit the menu mode, press the [MENU] key.
You can also exit the menu mode by pressing the
[CURSOR ] key as many times as required until
exiting the menu mode.
flashing