Troubleshooting, Mr-8 owner’s manual – Fostex MR-8 User Manual

Page 92

Advertising
background image

92

MR-8 Owner’s Manual

<Trouble 2>

The recorder stopped suddenly when record-
ing.

• Is there enough recordable space on the

CompactFlash card?

You cannot record onto the CompactFlash
card which is full. Replace it with a new card
or delete unnecessary data (see page 20).

<Trouble 1>

I am going to make recording using the inter-
nal microphone but I cannot see the input level
on the display.

Troubles for recording

If you encounter any problem while operating the MR-8, check the following for the possible
cause of the problem before contacting our service station or dealer.

<Trouble 3>

The meter shows very low level and actually
the recording level is too low.

• Is the [INPUT A SELECT] switch on the rear panel

set to "INT MIC"?

To make recording using the internal
microphone, set the switch to "INT MIC".

• Is the [TRIM] control for the [INPUT A] section

adjusted appropriately?

Set the sound source near to the internal
microphone or set the [TRIM] control just
below the position where the [PEAK]
indicator in the [INPUT A] section lights at
the loudest part.

• Is the [RECORD] key flashing and does

"

" light on the display?

Press the [RECORD] key to set the armed
(record-ready) track to the input monitor
mode by pressing only the [RECORD] key.

INPUT A SELECT

MIC/LINE

INT MIC

GUITAR

• Is the [TRIM] control for the input section the

sound source is connected adjusted
appropriately?

Set the [TRIM] control just below the
position where the [PEAK] indicator in the
[INPUT A] section lights at the loudest part
(see page 30).

BAL

UNBAL

/GUITAR

BAL

UNBAL

INPUT A

INPUT B

DISTORTION

TRIM

TRIM

PEAK

LINE

MIC

PEAK

LINE

MIC

MIN

MAX

GUITAR

INPUT A SELECT

<Trouble 4>

The meter shows good level for recording, but
no signal can be monitored via headphones
though the [PHONES VOL] control is brought
up.

• Are the track fader for the recording track and

the [MASTER] fader brought up?

Both of these fader, as well as the [PHONES
VOL] control, have to be brought up in
order to monitor the recording signal via
headphones.
We recommend to bring up both the track
fader for the recording track and the
[MASTER] fader to the “ ” position (see
page 32 and 34).

Troubleshooting

Advertising