Fostex MR-8 - Manual (Page 75)

75
MR-8 Owner’s Manual
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
LOCATE A
point
LOCATE B
point
ABS ZERO REC END
You can exchange parts between mono or stereo
tracks.
<Note>
You cannot exchange data of a song protected.
Release the protection before exchanging data.
1) Load the song you want to edit.
2) Store the LOCATE A and LOCATE B points (see
page 53).
You can check the part by playing back between
the LOCATE A and LOCATE B points (see page 68).
3) While the recorder is stopped, press the [MENU]
key to enter the menu mode.
The display shows the menu selection screen, in
which "
System " is highlighted initially.
4) Use the [CURSOR ] key to highlight "Part", then
press the [ENTER] key.
5) Use the [CURSOR ] key to highlight "Change
Part", then press the [ENTER] key.
The display now shows the screen for selecting the
source track(s) and destination track(s) of the
exchange operation. "Source Track" selects the
exchange source track(s), while "Dest. Track"
selects the exchange destination track(s).
6) Use the [CURSOR / ] keys to select the exchange
source track(s).
You can select from among mono tracks (1 through
8) and stereo pair tracks (1/2, 3/4, 5/6 and 7/8).
7) Use the [CURSOR ] key to move the cursor to
the option for "Dest. Track".
8) Use the [CURSOR / ] keys to select the exchange
destination track(s).
If you select a mono track for the exchange source
in step 6 above, you can select a mono destination
track. If you select stereo pair tracks for the
exchange source in step 6 above, you can select
stereo pair destination tracks.
9) Use the [CURSOR ] key to move the cursor to
"[ENTER]" at the lower right on the screen, then
press the [ENTER] key.
The display shows " Please Wait! ", immediately
followed by " Completed! " when the MR-8 completes
the part exchange operation.
To cancel the part exchange operation, move the
cursor to "
[CANCEL] " at the lower left on the screen,
then press the [ENTER] key.
The display now shows the part edit menu selec-
tion screen, in which "
Erase Part " is highlighted ini-
tially.
Exchange parts between tracks
<Note>
You cannot select the same track(s) for the
exchange source and destination.
flashing