FARGO electronic S000256 - Manual (Page 128)

RESTRICTED USE ONLY FARGO Electronics, Inc.
Using the Sensor Calibration
Step Procedure
1 Use the Sensors button in the Calibration window to bring up the Sensor
Calibration window for calibrating the Printer's ribbon and Sensors, as shown
on the next page.
2 a. Select the Ribbon Sensor Calibration to calibrate the Ribbon Sensor,
remove the Ribbon, and close the Printer’s top cover.
b. Click on the Send button.
c. Wait for the Printer to beep twice to indicate a completed calibration.
3 Click on the Self Test button to send a Self Test Print to the Printer. (Note:
Use this test print procedure to ensure the computer is effectively
communicating with the Printer, and that the Printer is functioning properly.)
Caution: There must be a full-color print ribbon installed.
Continued on the next page
Persona
® C25 Card Printer User Guide (Rev. 4.0)
128